SPECTRAN V5 COMMAND CENTER
The SPECTRAN V5 Command Center is, with its real-time bandwidth of up to 350MHz, an obvious all-in-one solution for all RF applications.
The V5 Command Center offers incredible 350MHz real-time bandwidth and a frequency range from 9kHz up to 20GHz. The Windows based system was developed specifically for mobile broadband frequency surveillance and drone detection, but it can be used for any and all RF applications. The two Full-HD monitors together with the high-performance hardware offer the required space and power in order to be able to measure, record and analyze signals over multiple bands simultaneously.
• Frequency range from 9kHz up to 20GHz (with low frequency option)
• Real-time bandwidth of up to 350MHz
• Up to 8 TB SSD (Hard Disk / Storage)
• Automatic Triggers programmable
• Simultaneous surveillance of multiple bands (3G, 4G, WLAN...)
• Real-time and sweep spectrum analyzer in one
• Including software with daily updates
The SPECTRAN V5 Command Center is a perfect solution for broadband surveillance. The 350Mhz real-time bandwidth in combination with the new RTSA Suite Software make it possible to monitor multiple frequency bands simultaneously in real-time. You could monitor 2G, 3G, 4G, GSM900, GSM1800, WLAN 2,4GHz and WLAN 5,8GHz at the same time and get a warning anytime an anomaly occurs. Alternatively, you could set the alarm trigger to specific signals. Another possibility is to use the 20GHz in 20ms sweep-mode to monitor the complete band from 1Hz up to 20GHz. This is a good setup, when you are uncertain at which frequencies the illegal or interfering signal transmissions will occur.
The system is capable of gaplessly monitoring and recording, 24 hours a day, 7 days a week. It produces 1GB of data per minute on average. This means, that the optional integrated 40TB storage capacity would suffice for data of about 28 complete days, before any transfers or hard-drive clean-up is necessary. The recorded data can later be used for audits or as supporting evidence.
The V5 Command Center was developed and designed as part of our Drone Detection System. This means that it, together with the IsoLOG 3D antenna-array and the RTSA Suite Software, is perfectly suited for the detection and accurate tracking of drones and other signals. The system can be taught to detect signal patterns other than drones, and give a warning or trigger another action once a signal that fits the pattern is detected.