All Prices In NZ Dollars 
Essential Physics Modular Circuits Kit, EM-3536
These circuit modules are designed specifically for introductory circuits investigations. For students who have never wired a circuit, this modular system makes it easy for them to see their circuit physically laid-out exactly as it appears in their circuit diagram.
Each module connects mechanically to another by sliding the tabs into each other. It works on any tabletop. No special surface is required. To electrically connect two modules, students insert a jumper clip, which emphasizes that an electrical connection has been made. The large size of the modules (8 cm x 8 cm) enables all the students around the table to see and understand the completed circuit.
Students will learn the correct way to insert an ammeter into a circuit: First they remove one of the straight wire modules from their circuit and then they replace it with the Wireless Current Sensor Module. Since the Current Sensor Module is in the same form factor as the other modules, it naturally fits in series with the circuit components. The fact that the Current Sensor is wireless helps the pedagogy: There is only one way in and one way out of the Current Sensor. There are no extra wires to confuse students.
Applications
- Kirchhoff’s Laws
- Batteries and Bulbs Circuits
- Switches, Open, and Closed Circuits
- RC and RLC circuits
- Electric Motors
This system is ideal for hands-on experimentation with basic circuits and includes more components than the Basic Set, as well as sensors. It is a component of the Essential Physics program.
What's Included
1x Wireless Voltage Sensor (PS-3211)
1x Wireless Current Sensor Module (EM-3534)
5x Straight Module
2x Tee Module
4x Corner Module
45x Jumper Clip
2x Battery Holder Module
2x AA-cell Battery
3x Light Bulb Module (with bulb)
1x SPST Switch Module
1x SPDT Switch Module
1x Potentiometer Module
1x 1000-Turn Coil/Inductor Module
1x Motor Module
1x 0.33 F Capacitor Module
1x 10 Ω Resistor Module
1x 33 Ω Resistor Module
1x 100 Ω Resistor Module
1x LED Module
1x Spring Clip Module
2x 1000 Ω Resistor
2x 330 Ω Resistor
1x 220 Ω Resistor
1x 22 Ω Resistor
1x 100 μF Capacitor
1x 330 μF Capacitor
1x Diode
8x Cylindrical Magnet 0.5 in x 0.25 in
1x Compass
1x Gratnells Case
These circuit modules are designed specifically for introductory circuits investigations. For students who have never wired a circuit, this modular system makes it easy for them to see their circuit physically laid-out exactly as it appears in their circuit diagram.
Each module connects mechanically to another by sliding the tabs into each other. It works on any tabletop. No special surface is required. To electrically connect two modules, students insert a jumper clip, which emphasizes that an electrical connection has been made. The large size of the modules (8 cm x 8 cm) enables all the students around the table to see and understand the completed circuit.
Students will learn the correct way to insert an ammeter into a circuit: First they remove one of the straight wire modules from their circuit and then they replace it with the Wireless Current Sensor Module. Since the Current Sensor Module is in the same form factor as the other modules, it naturally fits in series with the circuit components. The fact that the Current Sensor is wireless helps the pedagogy: There is only one way in and one way out of the Current Sensor. There are no extra wires to confuse students.
Applications
- Kirchhoff’s Laws
- Batteries and Bulbs Circuits
- Switches, Open, and Closed Circuits
- RC and RLC circuits
- Electric Motors