RigExpert TI-5000 Transceiver Audio Interface
Powerful USB transceiver interface based on high quality stereo codec IC, for operating phone, CW and digital modes using personal computer. All in one through a single USB port. Ideal interface for FT8 and WSJT modes!
- Description
Description
General features
- CAT (Computer Aided Transceiver) system
- CW keyer (WinKey)
- Footswitch input
- FSK output
- Microphone input
- PTT and CW outputs
- Transceiver audio interface for operating digital modes, voice recording and playback
Computer connection
- No external power supply needed
- Powered from the USB port (consuming 100 mA maximum)
- USB (Universal Serial Bus) connector
Transceiver connection
- Single 25-pin connector for transceiver cable
- Various transceiver models supported
Audio interface
- External microphone input with level control
- Input/output samplerate: 8 to 48 kHz
- Insulated from digital nets
- Maximum input/output amplitude is 1V
- Recording QSO audio stream
- Volume levels are adjusted by the front panel potentiometers
CAT serial port
- Baudrate: 300-115200 baud
- Electrical compatibility: RS-232, CI-V, TTL or inverted-TTL (Yaesu, Icom, Kenwood, Ten-Tec, Elecraft and JRC transceivers)
PTT/CW outputs
- CW output: open collector
- Maximum current is 50 mA
- PTT output: open collector and TTL-level
FSK output
- Baudrate: 45-1200 baud
- Open collector output
System requirements
- Desktop or laptop computer with USB 1/2/3 compliant port
- For Windows 7 and previous versions of Windows only FTDI drivers are required
- MacOS/Linux/Windows 2000/XP/2003/Vista/7/8/10 (32- or 64-bit) operating system
- No drivers required for systems on Windows 10/MacOS/Linux
Supported software
- all other soundcard software!
- MixW 2/3/4
- MMTTY, MMSSTV
- WSJT, WSJT-X, WSPR
